Precise RIAA correction.
8Hz subsonic filter.
MM version 40dB gain
MC version 60dB gain
Low noise: 82dB SNR.
Battery or AC operation.
The subsonic filter greatly reduces unwanted cone
movements due to record warp, etc.
Power is provided using a 15VDC external power supply.
The LN112 is available in two versions: Moving Coil and Moving Magnet. The special version for Moving Coil (MC) has as set of high performance Jensen MC transformers built into the unit. This gives the additional 20dB of gain required for the MC cartridge.
We use the highest quality parts, precision metal film resistors and polypropylene capacitors for superior sound. The preamp uses 4 12AX7WA dual triode tubes. The RIAA network uses a passive configuration. The power for the filaments is regulated 12VDC, using an internal voltage regulator. A DC/DC converter steps the 12V to 240VDC plate voltage.
The LN112 can be powered directly from a 12V battery (lead-acid battery) or from AV with adaper included.
Inputs: 1 pair of heavy duty gold RCA connectors.
Output: 1 pair of heavy duty gold RCA connectors.
Grounding: Binding post near input connectors.
Power: 2.1mm power jack for 15VDC power supply.
Frequency response: 20Hz - 20KHz +/- 0.25dB
Input impedance: MM: 47 KOhm + 120pF (other on request)
MC: 10 Ohm
Output Impedance: 500 Ohm.
Gain: MM:40dB @ 1KHz.
MC:60dB @ 1KHz.
Signal to noise ratio: MM:82dB ref. 5mV input@1KHz, A weighted.
MC:82dB ref. 0.5mV input@1KHz, A weighted.
Equ. input noise voltage: 0.04uVRMS, A weighted
Output load: 10KOhm or higher.
Max. output voltage: 7 VRMS.
Dimensions: 4" x 8" x 5"
Ordering Information:LN112-AA Phono Preamp, Moving Magnet version
LN112MC-AA Phono Preamp, Moving Coil version
These are available at amazon.com and directly from us LN112MM Tube Phono Preamp for Moving Magnet Cartridge LN112MC Tube Phono Preamp for Moving Coil Cartridge
UHF Magazine 79 www.uhfmag.com/Issue79/UHF79.pdf